↑ Return to R/C Achievement schemes

Multi Rotor solo test

To be approved  

 

cropped-New-KADMAC-logo-800x800.jpg

KADMAC Multi-Rotor solo test

 

First Name…………………………………………………………

KADMAC Membership Number…………………………….

Check List

Done

(a) Carry out pre-flight checks as required by the BMFA Safety Codes.
(b) Take off and hover 20 meters out and demonstrate failsafe/return to home function.
The following (c to j) tests to be completed with GPS switched off.
(c) Take off and hover tail in over the take off point, with the multi-rotor skids at eye level, for about  twenty seconds and then land
(d) Take off and hover for about five seconds then hover the multirotor slowly forwards for approximately five metres, stop, and hover for about five seconds.
(e) Hover the multi-rotor slowly sideways, either left or right, for approximately five metres, stop, and hover for about five seconds
(f) Hover the multi-rotor slowly sideways in the opposite direction for approximately ten metres, passing in front of the pilot, stop, and hover for about five seconds
(g) Hover the multi-rotor slowly sideways in the opposite direction for approximately five metres, returning to the position in front of the pilot, stop, and hover for about five seconds
(h) Fly slowly backwards, bringing the multi-rotor back over the take off point, stop, hover for about five seconds  and land
(i) Take off and fly forward for 5 metres, hover for about five seconds, then turn sideways 90 degrees either left or right and fly forward to perform two ‘lazy eights’, each at least 30 metres in length
(j) At the conclusion of the ‘lazy eights’, bring the multi-rotor to a halt above the centre point, turn tail-in to the pilot, hover for about five seconds and return to the landing pad
(k) Complete post-flight checks required by the BMFA Safety Codes.

 

(b) Members with craft not equipped with GPS, will be asked to remove their propellers and demonstrate failsafe in a safe area.

 

5 Questions will be asked from the KADMAC Solo Questions Achievement scheme.